Pads, coilover kits, springs and sway bars

Moderators: B17 Moderator, B16 Moderator

By infinity2134
#248252
Struts were rebuild and replaced by me and it started to drift to the left. Went to get an alignment and it is perfectly square. It also developed a wobble that could only be felt though the brake pedal at med/high braking pressure. Replaced the rotors and pads on the front and the drums on the back for good measure (they were almost done for). Same issue after all of this in done. Should I be looking at the struts again and getting some fully built kits to replace? I have the annoying clunk/doink when turning that seems to be an issue also. Thanks in advance!
User avatar
By XCLR8
#248382
The clunk might be from the sway bar end links in my experience.
When you say it drifts left do you mean during braking?
Gas Needle/Gauge

When I fill up sometimes my needle goes all the wa[…]

Gas Needle/Gauge

When I fill up sometimes my needle goes all the wa[…]

Gas Needle/Gauge

When I fill up sometimes my needle goes all the wa[…]

Gas Needle/Gauge

When I fill up sometimes my needle goes all the wa[…]